Posted on

growing skunk from seed

Dummies has always stood for taking on complex concepts and making them easy to understand. Dummies helps everyone be more knowledgeable and confident in applying what they know. Whether it’s to pass that big test, qualify for that big promotion or even master that cooking technique; people who rely on dummies, rely on it to learn the critical skills and relevant information necessary for success.

Learning Made Easy

Copyright © 2021 & Trademark by John Wiley & Sons, Inc. All rights reserved.

Autoflowering seeds are also popular with beginning growers. They are easy to grow because you don’t have to worry about light cycles and how much light a plant receives.

Many marijuana growers start autoflowers early in the season, and at a different time than a regular crop, so keep the season and climate in mind when growing and harvesting—your plants still need warmth to grow, and rain can give them bud rot. Consider growing in a greenhouse to protect them.

Pros and cons of growing autoflower

Cultivating males is important for breeders trying to cross new strains and genetics, but most people growing for buds will want to remove the males.

Seeds for these varieties are now widely available online and through dispensaries. It should be noted, however, that any plant grown from these seeds is not guaranteed to produce high levels of CBD, as it takes many years to create a seed line that produces consistent results. A grower looking to produce cannabis with a certain THC to CBD ratio will need to grow from a tested and proven clone or seed.

If you’re ready for a more serious approach, make sure you have the space for a proper garden and pop the seeds to see what fruit they bear.

Raising a seedling, however, requires some patience, gentle hands, and a smidgen of luck. Thankfully pot seeds are remarkably vigorous because they are what’s called endosperm seeds, which means they have almost pre-formed cotyledon leaves before you even add water. Below is a brief guide on the techniques we have found yield the most success when starting seeds and raising your seedling to a healthy plant ready for transplanting.

To accelerate germination, you are going to want to soak your seed in a small container with lukewarm water and place it in a dark and warm place for 12-24 hours, but no longer. By drenching the seed, it absorbs the water thoroughly, activating the germination process. Doing this also helps to loosen the shell as it becomes a little softer making it easier for the embryo to crack it open. When your seed sinks to the bottom it is ready to be planted, and sometimes the seed will pop out a small taproot. A seed can still be planted though if it does not sink.

Starting From Seed

Seedlings require a medium amount of light in which it has enough to grow but not too much light that it gets burned. Leaving your seedling in direct sunlight will cause the leaves to curl, while too little light will cause the seedling to stretch. If growing outside, seedlings want to see a direct light source to stop them stretching. If inside, a sunny windowsill with more than half a day of sunlight works wonders. Otherwise, 18 in away from a growing light works excellently. Your seedling should not stretch more than 6 in at most. We’ll cover lighting in more depth in a later blog.

We like to use seedling pellets that are made of a mix of compressed peat moss and coco husk. To expand, soak it in water for 10 minutes. Once your seedling pellet has absorbed enough water and has expanded to its maximum size, drain off any excess water. The growing medium should be like a damp sponge that would not leave streaks on the table. Dig a small hole about 1/4 in deep for your seed. Use a spoon to lift the seed out of its bath. If it has popped out a taproot be careful not to damage it. Gently place the seed into the hole and lightly cover it with dirt from the pellet. Now that you have started the germination process, your seedling will come above ground within two weeks. The older the seed, the longer it takes for it to germinate.

For young plants, it’s best to use bottled water as it has no chlorine added. If using tap water, let it sit for 24 hours before watering to dissipate any chlorine. Chlorine can also be eliminated by boiling for 20 minutes. Under normal conditions, after soaking your seedling pellet, it should contain all the moisture your plant needs before it comes above ground. As it grows, it will only need about a shot glass worth of water at most per week to keep the medium damp. Seedlings don’t drink a lot of water, which makes sense given their size. Your plant will do better in a growing medium which is damp. Overwatering is just as deadly as drying out.